.
14" Bandsaw Support Post Bracket complete with adjusting screws, side guide fork, rub blocks and thrust bearing assembly.Fits all saws with a 7/8" post end Measure your post to be sure. This is for the 7/8" round bottom post.May come unassembled, picture shows it assembledRigid part # 823601 Fits 14000, 14001, and 14002 sawsas well as any other brand with a 7/8" guide post
Items 45, 46-(x2), 47-(x2), 51-(x2), 52, 53, 54, 55, and 56, 57, 58 below:
GUIDE ADJUSTMENT: To adjust the guide first move both upper and lower guide rub blocks and thrust bearing away from blade so it does not touch them. Then adjust the lower side guides so that they just touch the blade behind the teeth. Repeat with upper guide. Then adjust the thrust bearings so that they almost touch the rear edge of the blade with no load. Snug thumb screws on blocks and tighten thumb screws on Rub block fork and thrust bearing.
DO NOT OVER TIGHTEN THE SET SCREWS THAT HOLD THE GUIDE BLOCKS IN! THEY NEED ONLY BE SNUG.
Over tightening is a beginners mistake and is the only cause for this part to ever fail.I sell many bandsaw parts write me with your needs if you can not find them here or below:
Repair Sheet and Parts list in PDF for 14002 emailed 2 you. Item #152789827025
Lower blade guide:Item # 112243893475
Upper blade guide Bracket Item # 112458411734
Blade guide rub block fork Item # 152602074436
Upper Wheel tension Slide only Item #152829588313
Upper Wheel Hinge and Shaft Item # 152708355661
Complete Upper wheel tension assembly Item # 152602070912
Table trunnion support bracket 112458425276
Rub blocks for blade guide Item # 152480378450
Trunnion shoe clamps Item # 112577506256
Table Alignment Taper Pin Item # 152733386309
Ball Bearing Guide Upgrade Item # 112617014304
Door Catch Item #152778061716
Door Catch Stud & Knob Item # 152778067840
Upper Guide Post Complete w/Hardware Item # 152779261500
20% restocking fee on returns
All sales ship to address registered with Ebay at the time of the sale.